SRAM GCP Pressfit MTB Bottom Bracket 92mm

The SRAM GCP 92mm Pressfit MTB Bottom Bracket is a top - notch component for your mountain bike. It's designed to fit SRAM and Truvativ GXP cranksets onto frames with either a BB86 - Road (86.5mm width) or BB92 - MTB (92mm width) 41mm - ID press - fit, non - threaded bottom bracket shells. Note that it's not suitable for BB90 - Trek or BB30 systems. It comes with a 37x24x8mm bearing set, a wave washer, and bearing shields for use on Giga X Pipe cranks with an integrated 24mm GXP spindle. You can choose between BlackBox (hybrid - ceramic bearing) or Team (steel, sealed bearing) in press - fit, internally sealed composite cups. For installation, using a shop - quality headset press is recommended.

Using the SRAM GCP 92mm Pressfit MTB Bottom Bracket is easy. First, make sure your bike frame has a BB86 - Road or BB92 - MTB bottom bracket shell as it won't work with BB90 - Trek or BB30 systems. Then, take the bearing set with the wave washer and bearing shields and install them onto the Giga X Pipe cranks with the integrated 24mm GXP spindle. When it comes to the cups, you have the option of BlackBox or Team. Installation is best done with a shop - quality headset press. As for maintenance, keep it clean by wiping it down after each ride. Check the bearings regularly for any signs of wear or damage. If you notice any strange noises or reduced performance, it might be time to replace the bearings or the whole bottom bracket.