Topeak Tri-Backup Elite Mount for angled rail section

Being elite means never compromising when aiming for perfection. Every little detail counts. One key performance tip is to mount your gear in a way that minimizes drag. The Topeak Elite Mount offers two options. The Elite 90 is specially designed for triathlon saddles with vertical rear rails, while the Elite is for saddles with angled rear rails. It has angle - adjustable functionality and can hold one or two bottles. Made of CNC aluminum, it mounts on the V - rail section of the saddle and is compatible with CrMo, Ti, and Carbon rails. The hydration capacity allows for one or two bottles, each up to 750cc. It can handle a max load of 2.5 kg (5.5 lb). It's compatible with Ninja TC Road, Ninja Pouch+ Road, Ninja CO2+ and Tri - Cage series. It comes with 1 Micro AirBooster and 2 16g CO2 cartridges. Measuring 8.6 x 7.6 x 7.4 cm (3.4” x 3” x 2.9”) and weighing 102 g (3.60 oz) in total or 88 g (3.10 oz) without the Inflator Bracket, this mount is a great addition to your triathlon setup.

Using this Topeak mount is easy. First, figure out if your saddle has vertical or angled rear rails. If it's vertical, go for the Elite 90 option; if angled, the regular Elite is your choice. Adjust the angle to your preference so you can minimize drag and make your ride more efficient. You can put one or two bottles in it, as long as each bottle is no more than 750cc. When it comes to the load, don't put more than 2.5 kg (5.5 lb) on it. As for maintenance, keep it clean. After a ride, wipe it down with a dry cloth. If it gets wet, dry it thoroughly to prevent any rust or damage to the CNC aluminum material. Make sure the mount stays tightly attached to the saddle's V - rail section. And remember, it's compatible with specific Ninja series products, so use them for the best results. Also, take care of the included Micro AirBooster and 16g CO2 cartridges and replace them when needed.